Development and validation of a simple microwave-assisted digestion sample preparation technique for the estimation of aluminium and magnesium in a few pharmaceutical dosage forms by an inductively coupled-mass spectrometer (ICP-MS).

Rationale: A simple, sensitive, reliable, validated, inductively coupled plasma mass spectrometric method for the determination of aluminium and magnesium using a simple common microwave-assisted digestion sample preparation technique for a few commonly used formulations was developed and validated according to International Conference on Harmonization Q3D and the United States Pharmacopeia general chapter <232> and <233>. The following pharmaceutical dosage forms were considered for estimation of aluminium and magnesium: Alumina, magnesia simethicone oral suspension, Alumina, magnesia simethicone chewable tablets, alumina and magnesia oral suspension, alumina and magnesium carbonate oral suspension. Methods: The methodology included optimizing a common microwave assisted digestion method, selecting the isotopes, choosing the measurement technique, and designating internal standards. The finalized microwave assisted procedure was a two-step program where in the first step the samples were ramped for 10 min to a temperature of 180 °C and hold for 5 min followed by ramping for 10 min to a temperature of 200 °C and hold for 10 min. Magnesium (24Mg) and aluminium (27Al) isotopes were finalized, internal standard assigned for both the isotopes was yttrium (89Y) with Helium (kinetic energy discrimination-KED) as the measuring mode. System suitability was run before initiating analysis to ensure that system performance was consistent. Results: Analytical validation parameters like specificity, linearity (from 25% to 200% of sample concentration), the detection limit and the limit of quantification were established. For all these dosage forms, the method's precision was demonstrated by analyzing the percentage relative standard deviation for six injections. Accuracy was established from 50% to 150% of instrument working concentration (J-levels) for aluminium and magnesium for all the formulations and was found to be within the range of 90-120%. Conclusion: This common analysis method, along with the common microwave-digestion technique applies to numerous types of matrices for a finished dosage form with aluminium and magnesium.

Determination of arsenic, cadmium, mercury, lead and nickel as elemental impurities in atorvastatin calcium by inductively coupled mass spectrometer.

Atorvastatin calcium is employed as front-line treatment for cardiovascular diseases. According to the international conference on harmonization (ICH) guideline ICH Q3D, elemental impurities can come into drug products from various sources. These elemental impurities do not have any therapeutic benefit to the end-user. On the contrary, it harms the normal physiological system. Class 1 elements like arsenic, cadmium, mercury, and lead are inorganic impurities that can cause toxic effects on the human body. Nickel was used as a catalyst during the synthesis process of atorvastatin calcium. It comes under the Class-2A, can cause toxicity to humans, and must be quantified. A simple, fast, reliable inductively coupled plasma mass spectrometric method for the estimation of elemental impurities like arsenic, cadmium, mercury, lead, and nickel in atorvastatin calcium by open sample digestion technique was developed and validated in accordance with ICH Q3D and USP < 232 > and USP <233 > general chapter. Internal standards like indium, terbium, thallium, bismuth and yttrium were used to correct the non-spectral interferences that were generated during analysis. Gold was added to all solutions as it preserves mercury by amalgamation. The system performance was evaluated every time my performing system suitability parameters. The limits for all the elements were fixed in accordance with ICH Q3D. The limit of detection and the limit of quantification for all the five elements were estimated. Method specificity was proven by checking for interferences due to the sample matrix and other elements. Linearity of each element in standards was established from 25% to 200% of sample concentration, and correlation coefficients were found to be not less than 0.999. The accuracy of the method was demonstrated at three spiking levels at 50%, 100%, and 150% of the J-value for all the elements. The recoveries for all elements at each level were within the range of 90-120%. Method precision was proved at 100% J-value. The relative standard deviation of all elements was less than 5%. It concludes that this newly developed and validated reliable inductively coupled plasma mass spectrometric method for estimating of elemental impurities like arsenic, cadmium, mercury, lead, and nickel in atorvastatin calcium was within the permitted limit and suitable for routine use.

Nucleotide diversity and phylogenetic relationships among Gladiolus cultivars and related taxa of family Iridaceae.

The plastid genome regions of two intergenic spacers, psbA-trnH and trnL-trnF, were sequenced to study the nucleotide diversity and phylogenetic relationships among Gladiolus cultivars. Nucleotide diversity of psbA-trnH region was higher than trnL-trnF region of chloroplast. We employed Bayesian, maximum parsimony (MP) and neighbour-joining (NJ) approaches for phylogenetic analysis of Gladiolus and related taxa using combined datasets from chloroplast genome. The psbA-trnH and trnL-trnF intergenic spacers of Gladiolus and related taxa-like Babiana, Chasmanthe, Crocus, Iris, Moraea, Sisyrinchium, Sparaxis and two out group species (Hymenocallis littoralis and Asphodeline lutea) were used in the present investigation. Results showed that subfamily Iridoideae have sister lineage with subfamily Ixioideae and Crocoideae. H. littoralis and A. lutea were separately attached at the base of tree as the diverging Iridaceae relative's lineage. Present study revealed that psbA-trnH region are useful in addressing questions of phylogenetic relationships among the Gladiolus cultivars, as these intergenic spacers are more variable and have more phylogenetically informative sites than the trnL-trnF spacer, and therefore, are suitable for phylogenetic comparison on a lower taxonomic level. Gladiolus cultivars are extensively used as an ornamental crop and showed high potential in floriculture trade. Gladiolus cultivation still needs to generate new cultivars with stable phenotypes. Moreover, one of the most popular methods for generating new cultivars is hybridization. Hence, information on phylogenetic relationships among cultivars could be useful for hybridization programmes for further improvement of the crop.